C1A00-54 (28) Control module - System programming failure - missing calibration. Simple fix. I used my IID GAP tool and calibrated it. Under the main menu click CALIBRATION …
Fault code C1A00-54 (AF) in Active Roll Control: Morning all, a bit of a head scratcher… My rear arb had developed a leak but otherwise all was working well. I’ve replaced …
All three height modes still function as normal but no height change is registered on the screen display. I have RSW solutions software. Codes are "control module" c1a00 (not a complete code I know) and "VIN …
I have borrowed a friends Launch x431 Scan tool and under the menu Ride Level Control Module, Its coming up only with Fault code C1A00 Control Module. Other control …
What is causing my suspension to not raise/lower. The back of my SUV is pretty low (after jacking up and changing the wheels), and every once in a while I will get an error …
Activating the geometry setting mode will cause the air suspension warning lamp to be illuminated and the diagnostic trouble code (DTC) C1A00-54 to be logged. However, when …
I have a suspension problem with my car. Flash the red supsension fault lamp in the dashboard, and the fault code is C1A00-54. I.
Range Rover suspension warning light on dashboard. The Range Rover Sport suspension warning light typically indicates leaks, faulty height sensors, or a failing …
the fault code is C1A00-54 suspension control module permanent. The previous garage tried to calibrate the air suspension and got this message. Today I dropped it to a …
You should check this: " Activating the 'Tight Tolerance Mode' will cause the air suspension warning lamp to be illuminated and the DTC C1A00-54 to be logged. When the …
C1A00-54 RLCM permanent fault. This will not clear, I have tried several times. It stays in normal height mode but will not allow me to raise or lower the vehicle.
amber light showed then red as we tryed to reset the suspension. now the suspension doesnt do anything. so i went to my local landy garage as it was a.
Hello, after trying but failing to calibrate my suspension using the Autel software I am now getting the following error code C1A00-54, any help would much appreciated, thanks …
Recently purchased a Range Rover sport 2006 2.7 diesel. It flagged up on the dash suspension fault. When scanning it showed suspension building pressure too slow and worked …
Еще по теме:
Еще по теме:
